Billion BiPAC 5100 User Manual download pdf (Page 37)

Threshold messages. It is the maximum data fragment size that can be sent.

Enter a value between 256 and 2432.

WEP Encryption WEP (Wired Equivalent Privacy) encrypts data frames before transmitting over the

wireless network.

Select Disable to allow all wireless computers to communicate with the access points

without any data encryption.

Select 64-bit WEP or 128-bit WEP to use data encryption.

Key 1 to Key 4 The WEP keys are used to encrypt data. Both the BIPAC-5100/5100W and the

wireless stations must use the same WEP key for data transmission.

If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal

characters ("0-9", "A-F").

If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal

characters ("0-9", "A-F").

You must configure all four keys, but only one key can be activated at any one time.

The default key is key 1.

IP Address Enter the IP address of your BIPAC-5100/5100W in dotted decimal notation, for

example, 192.168.1.254 (factory default).

IP Subnet Mask Type the subnet mask assigned to you by your ISP (if given).

RIP Direction

Select the RIP direction from None, Both, In Only and Out Only.

RIP Version

Select the RIP version from RIP-1, RIP-2B and RIP-2M.

Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol used to establish

membership in a multicast group. The BIPAC-5100/5100W supports both IGMP

version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.

Back

Click Back to go to the main wireless LAN setup screen.

Apply

Click Apply to save your changes back to the BIPAC-5100/5100W.

Cancel

Click Cancel to begin configuring this screen afresh.

5.5 Configuring MAC Filter

The MAC filter screen allows you to configure the BIPAC-5100/5100W to give exclusive

access to up to 32 devices (Allow Association) or exclude up to 32 devices from accessing the

BIPAC-5100/5100W (Deny Association). Every Ethernet device has a unique MAC (Media

Access Control) address. The MAC address is assigned at the factory and consists of six pairs

of hexadecimal characters, for example, 00:AA:BB:00:00:02. You need to know the MAC

address of the devices to configure this screen.

To change your BIPAC-5100/5100W’s MAC filter settings, click Wireless LAN, MAC Filter to

open the MAC Filter screen. The screen appears as shown.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 85 86

No comments

Billion BiPAC 5100 User Manual Page 37